Showing posts with label Lathe. Show all posts
Showing posts with label Lathe. Show all posts

Tuesday, September 10, 2024

Ranger Biodiesel Swap - Flywheel And Bellhousing Adapter Installation

With the bellhousing and crankshaft adapters finished, it was time to start assembling the backend of the engine. I received the bellhousing adapter from the machine shop, confirmed the hole alignment with my bellhousing, and then torqued it to the engine block.

 



Next, I installed the crankshaft adapter and crankshaft. Both pieces received brand-new hardware that were loctited and torqued to spec.




The original flywheel and pressure plate were in good condition, so I rebuilt both and installed a new clutch friction plate.



The final piece was the bellhousing, which required some mild clearancing to not interfere with the coolant adapter on the back of the cylinder head,










With everything painted and reassembled, it was time to work on the starter, clutch linkage, and transmission installations.

Tuesday, October 24, 2023

Ranger Biodiesel Swap - Alternator Adapters

 To simplify wiring, I decided to mount the original Ford alternator on the VW engine. There's no tensioner pulley for the serpentine v-belt, so I fabricated a hinged adapter and tensioning rod.


The first version of the hinged adapter was made from billet aluminum. 




Next, I turned an aluminum v-belt pulley on my lathe, to match to profile of the original VW pulleys.







Finally, I bent a steel bracket that curves around the outside of the alternator and bolts to the engine block. With an 8mm socket cap bolt and fender washers, I made a tensioner that pulls the belt tight, rather than pushes.


After installing the engine, I discovered that the alternator was hitting the steering u-joint and needed to be rotated higher. The aluminum hinge was at its limit of travel, so I made a replacement out of steel that allowed better clearance.









Wednesday, September 7, 2022

Ranger Biodiesel Swap - Fuel Tank Modifications

The original fuel pump, pressure regulator, and bypass hose are submerged inside the tank, and the fuel system only has a single hose to the injection system on the engine. 

The pump itself isn't rated for diesel or biodiesel, and I want to install a recirculating fuel system with an external pump and separate fuel return line to the tank, so it was necessary to dismantle the stock components and make modifications.

I started by removing the fuel pump and regulator assembly from the sending unit, and pulling the pump wires out of the bulkhead fitting. I sealed the holes in the bulkhead with marine epoxy, spliced the pump wires to a 6ft extension, and coiled them up for later use with an external pump.


I replaced the fuel pump and regulator with a custom pickup tube made from the following components:

- 3/8" ID SAE30R10 Submersible Fuel Line (6")
- McMaster-Carr P/N 5357K36 - 3/8" Barb x 1/4" MNPT Hose Fitting
- McMaster-Carr P/N 1610T14 - 6061 Aluminum 1-3/4" Dia, 3" Long

I turned the aluminum bar on a lathe to surface and chamfer the ends, then drilled a 3/8" through-hole and tapped to 1/4" NPT on one side.


The turned aluminum bar fits into the space vacated by the submerged pump, and is secured by the stock clamp. Once completed, I reinstalled the modified sending unit in the tank.






 

Saturday, February 27, 2016

Biodiesel Sportster Land Speed Racer - Part 13 - Odds and Ends

Here are all the various pieces that had to be fabricated. It's always those last details that drive you crazy and eat up your time!

K&N Round Filter Adapter

Made several grocery bags worth of chips....




CVT Cover

Hand-hammered from aluminum.



Rear Struts





Frame-Stiffening Bracket




Secondary Shaft Keyways